Dynamic Pressure Transducers - Discontinued

DPX101

Dynamic High Speed Pressure Transducers

Ver Todas los Modelos Abajo

For Dynamic and High Frequency Pressure Measurements
Ideal for Monitoring Explosion or Pulsation Pressures
1 Micro-Second Rise Time
Welded Flush Diaphragm
Pressure Ranges up to 5000 psi
High Level 5 Volt Output
Calibration Certificate Supplied
High Frequency Acceleration Compensated

Descripción

The DPX101 series has been discontinued. Please contact our Pressure Engineering department for possible alternatives.

OMEGA’s DPX101 dynamic pressure transducers are ideal for measuring pressure transients or dynamic pressure pulsations in liquids or gases. With their wide dynamic range, they can measure pressure events with rise times as fast as 1 µs, frequencies to hundreds of kHz, and pressure levels down to fractions of a psi. Using pure synthetic quartz crystals under high compressive preload, these transducers produce a clean, low-impedance voltage signal compatible with many readout instruments.

SPECIFICATIONS
Excitation: 2 mA nominal @ 18 to 30 Vdc, constant current
Rated Output: 5V nominal FS
Rise Time: 1.0 µs
Resonant Frequency: 500 kHz
High Frequency Range: 170 kHz (approx. 1/3 of resonant frequency)
Low Frequency Range (-3 dB):
   DPX101-250: 0.08 Hz
   DPX101-500: 0.03 Hz
   DPX101-1K: 0.02 Hz
   DPX101-5K: 0.003 Hz
Acceleration Sensitivity: 0.002 psig
Discharge Time Constant:
   DPX101-250: 2 s
   DPX101-500: 5 s
   DPX101-1K: 10 s
   DPX101-5K: 50 s
Proof Pressure:
   DPX101-250: 5000 psi
   DPX101-500: 10,000 psi
   DPX101-1K: 10,000 psi
   DPX101-5K: 15,000 psi
Overload Recovery: 10 µs for 2x range
Maximum Shock: ±10,000 g peak
Maximum Vibration: ±5000 g
Amplitude Linearity: ±1% FS (BSFL/0)
Temperature Range: -75 to 120°C (-100 to 250°F)
Temperature Sensitivity Effect: 0.03% FS/°F
Output Impedance: 100 Ω
Bias Voltage: 10V nominal
Noise Floor (Wideband, RMS):
   DPX101-250: 0.004 psi
   DPX101-500: 0.007 psi
   DPX101-1K: 0.014 psi
   DPX101-5K: 0.07 psi
Weight: 14 g (0.5 oz) nominal
Material: 316L SS diaphragm, 17-4 SS housing
Connector: 10-32 male termination (cable sold separately; order Model No. ACC-CB2-10)

Hacer Pedido(Especifique el Número de Modelo)

Lo que han comprado otras personas: Cuando vea este icono, haga clic sobre él para abrir la lista de productos que otras personas han comprado al adquirir este modelo

Número de parte/Desc.

Cant.

Descripción

DPX101-250

Consultar Ventas

Disponible en:

0-250 psig dynamic pressure transducer

DPX101-500

Consultar Ventas

Disponible en:

0-500 psig dynamic pressure transducer

DPX101-1K

Consultar Ventas

Disponible en:

0-1000 psig dynamic pressure transducer

DPX101-5K

Consultar Ventas

Disponible en:

0-5000 psig dynamic pressure transducer

ACC-CB2-10

Consultar Ventas

Disponible en:

10 foot coaxial cable (10-32/BNCM) required

Accessories

DPX-NPT

Consultar Ventas

Disponible en:

1/8 NPTM flush mount adaptor

DPX101-3824

Consultar Ventas

Disponible en:

3/8-24 flush mount adaptor

DPX-6600

Consultar Ventas

Disponible en:

Replacement brass seal for DPX-NPT

Power Supplies

Cables

ACC-CB4-15

MXN2,570.00

Disponible en: Disponible

15 foot caoxial cable (BNCM/BNCM)

ACC-CB5-2

MXN2,320.00

Disponible en: 7 Semanas

2 foot caoxial cable (BNCM/banana plug)

ACC-CB6

MXN995.00

Disponible en: Disponible

7" coaxial cable (BNCM/pigtail)

Todas las cantidades que se muestran en MXN
Nota: Each DPX101 is supplied with two (2) DPX-6600 seals.
A complete system is a dynamic pressure transducer, a power supply, and two cables; one between the load cell and the power supply and one from the power supply to your data system.

Ejemplo de pedido: (1) ACC-CB5-2 2 ft BNC to banana jack cable, MXN2,320.00

Productos Relacionados: