The FPU2000A Series fixed pumps feed by an analog fixed 60 second timer. The pump can be on for
1 to 60 seconds. All FPU2000A Series have fixed speed outputs and can be adjusted by selecting the pumphead tube size and choosing the desired RPM (revolutions per minute).
Standard Percentage & Digital Percentage Controllers
The FPUVS2000A and FPUDVS2000A Series variable speed pumps are for continuous pumping relatively pulse free, even while adjusting the percentage of output. The variable speed pump requires the use of brushes on the DC motor. Excellent brush life expectancy (2000 hours). An extra set of brushes included with every pump.
The FPUDVS2000A Series will accept any one of three different types of external input signals;
4 to 20 mA, 0 to 10 Vdc, or frequency. The 4 to 20 mA and 0 to 10 Vdc loops must be powered.
Two types of frequency inputs, AC sine waves (magnetic coils type outputs) and digital square waves (Hall Effect signals, contact closures), are acceptable. A jumper plug located on the circuit board is factory pre-set for AC sine wave signals, the jumper must be re-positioned when digital square wave signals are being used. All wiring connections are to be made inside of the junction box located on the side of the FPUDVS2000A Series. A liquid tight connector is
supplied and should be used for the external signal cable. The signal input wires are color coded to the type of signal being used.
SPECIFICATIONS Maximum Working Pressure:
100 psig/6.9 bar (most models) Maximum Fluid Temperature:
54°C (130°F) Ambient Temperature Range:
-10 to 43°C (14 to 110°F) Enclosure: NEMA 3R (IP24)
(acceptable for indoor use) Pump Tube Material: Norprene® Duty Cycle: Continuous Maximum Solids: 50% by volume Maximum Viscosity: 5000 Centipoise Maximum Suction Lift:
Up to 9 m (30') water Turn Down Ratio: 20:1 Power Requirements: 115 V 60 Hz
80 Watts, 220 V 50 Hz 40 Watts,
230 V 60 Hz 45 Watts Variable Speed: 115 V 60 Hz
40 Watts, 220 V 50 Hz 40 Watts,
230 V 60 Hz 40 Watts Dimensions:
155.6 H x 257.2 W x 228.6 mm D
(6⅛ x 10⅛ x 9") Variable Speed:
159 H x 254 W x 235 mm D
(6¼ x 10 x 9¼") Weight: 3.6 kg (8 lb) Tube Connection: Compression barb
type (⅜” ID x ¼" OD)
* Only 220 Vac/50 Hz and 230 Vac/60 Hz
models are CE approved.
Todas las cantidades que se muestran en MXN Nota: Comes complete with suction tube strainer, tube weight, suction tubing, discharge tubing, and injection fitting with internal back-flow check
valve, mounting hardware, and operator’s manual. FPUVS and FPUDVS come with an additional set of brushes.
To order CE approved 220 Vac/50 Hz model, add suffix “-220/50” to model number, no additional charge. To order CE approved 230 Vac/
60 Hz model, add suffix “-230/60” to model number, no additional charge. Note: 220 Vac/50Hz fixed speed models output approximately
Did you know Omega has an office in the United States with local pricing and live engineers to support you in your time zone?