The DRTB-Rails Series DIN Rails enhances design capabilities, saves space and reduces labor. DIN rails have been accepted throughout the world, allowing the designer to mount a wide variety on control components, devices and terminal blocks, etc. on the same rail.
DRTB-Rails are perforated steel with electrolytic zinc plating and available in 35x7.5mm and 35x15 mm sizes. These DIN rails comply with DIN 50045, 50022 and 50035 standards.
Pre-Cut DIN Rails
Pre-cut DIN rails are offered in widths to match enclosure sizes. An enclosure, 12H x 10” W, would use DRTB-RAIL-10. This DIN rail measures 8.75" wide, just short of the 8.88" wide sub-panel.
Support Brackets Support brackets elevate DIN rails away from the sub-panel to facilitate component wiring access. Angled brackets tilt the DIN rails by 45° to improve visibility. Straight brackets are available in three heights for optimum positioning of the rails.
Dimensions mm(in)
Brackets include screws & lock washers
Todas las cantidades que se muestran en MXN Ejemplo de pedido:
(3) DRTB-RAIL-10 3 pieces of pre-cut 35x7.5mm DIN rail for 10, MXN333.000 plus (1) DRTB-RAIL-3575 35x7.5mm DIN rail, 2 m long, MXN373.00 plus (1) DRTB-RAIL-3575-1 35x7.5mm DIN Rail, 1 m long, MXN201.00, MXN333.00 X 3 + 373.00 + 201.00 = MXN1,573.00
Productos Relacionados:
DIN Rail Terminal Blocks, Feed Through and Ground Terminals