Lightweight Plastic Design for Multiple Mounting Positions
•
High Accuracy: ±2% of Reading
•
High Repeatability: ±0.5% of Reading
•
Over-Molded Electronics with Integral Cable Strain Reinforcement
The FTB-430 is no longer available. Please refer to our
BV1000-2000-3000-Series as an alternative
.
The FTB-430 Series is a highly accurate and
repeatable, hall effect turbine flow sensor designed
for low flow OEM applications. This low cost, NSF
Standard 61 listed flow sensor is ideal for water or
beverage dispensing applications or any application
with water based liquids. The 316SS shaft coupled
with Polyoxymethylyne bearings allows for accurate
measurements during quick dispensing cycles. The
sensor’s standard power and output specifications
make it easy to retrofit existing controllers.
Specifications Materials:
Body glass reinforced PPO
Turbine PA composite (nylon)
Axle 316 stainless steel
Bearings Polyoxymethylyne, POM Inlet/Outlet Ports: 3/8 NPT male Pressure: Operating: 200 PSIG Burst: 1000 PSIG Operating Temperature: -20 to 80°C (-4 to 176°F) Viscosity: 32 to 81 SSU (0.8 to 16 centistokes) Recommended Filtration: < 50 microns Input Power: 5 to 24 Vdc @ 8 mA Output (Hz): NPN sinking open collector @ 25 mA Pulses per Gallon: FTB-431: 10,313 FTB-432: 4994 Maximum Leakage Current: 10µA (5 to 30k pull-up resistor required) Accuracy: ±2% of reading Repeatability: ±0.5% of reading Electrical Connection: 0.91 (3') PVC cable #22 AWG
† All dollar amounts on this site are shown in US currency.
