The WT-3200 is a unique, fully controllable wind
tunnel for thermal and air flow testing of multiple
PCBs. The test chamber has a 2-D converging nozzle
with a multi-point measurement area for sensor
placement upstream of the test section. The test
section is equipped with card guides to allow insertion
of actual or simulated PCBs from the side panel.
The WT-3200 wind tunnel can be used to characterize
different heat sink sizes for natural and forced
convection cooling. Two heat sinks can be tested side
by side to determine their thermal performance in
the same environment. Actual or simulated PCBs can
be tested for thermal flow distribution and pressure
drop characterization.
The chamber can accommodate up to 6 PCBs with
13 mm (0.5") card-to-card spacing or 3 PCBs with
25 mm (1") card-to-card spacing.
The test section is made of clear polycarbonate
material to accommodate smoke flow visualization.
The chamber has its own stand for placement of
instruments. The WT-3200 is placed on castors for
ease of transportation. Rail guides are provided so the
unit position can be adjusted. A switch box is provided
with the unit so individual fans can be turned on or off.
The WT-3200 can be fitted with different fan trays
to accommodate a broad air flow range. Sensors to
measure the flow parameters are also availabled by
Omega as optional accessories.
Specificat ions Wind Tunnel: 214.5 L x 114.3 W x 91.3 cm D (84.4 x 45 x 35.9") Test Section: 60.9 L x 46.9 W x 7.6 cm D (24 x 18.5 x 3") Number of Sensor Ports: 18 Flow Range: 0 to 10 m/s (0 to 2000 ft/min) Flow Uniformity:±1% Weight: 74 kg (164 lb) Power Supply Requirements: 24 Vdc at 4.3 Amps (Power supply provided by customer)
† All dollar amounts on this site are shown in US currency.
Note: Comes complete with (18) sensor ports, fan control box and operator’s manual.